29 spline, for 1410 series U joint. "B"= 3.720"
3/8" diameter bolts with nuts and washers. Set of 8.
3/8" diameter bolts with nuts and washers. Set of 10.
Dana 60, 3.812" O.D. (pr)
Ford 9", 3.250" O.D. (pr)
Complete Dana 60 rearend assembly with locker (less brakes)
Economy rearend assembly for Dana 60™. (less brakes)
MW 35-spline, Lightweight for Dana 60™
MW 40-spline, for Dana 60™
MW 40-spline, Lightweight for Dana 60™.
Features threaded adjusters and bolt pattern for pinion snubber
29 spline, for 1350 u-joint. "B"=3-1/32"
Dana 60™, 35 Spline locker for 4 series gears
Powr-Lok™ Axle gear for Dana 60™ with 35 splines (ea)
Dana 60™, 40 Spline locker for 3 series gears
Includes cover and bolts
Includes shims and bearings for pinion and carrier, pinion seal, preload shim, ring gear bolts, pinion nut, cover gasket, gear marking compound, and brush
Kit includes pinion depth shims, pre-load shims, spool shims, gasket, pinion nut and washer.
Dana 60™ threaded adjuster housing with 3" x .250" 4130 tubes.
For using 4.56 to 7.17 ratio gear on 3.54 to 4.10 carrier
Timken® bearings and races for Dana 60™
Replacement cap, billet steel, (each)
For Dana 60™, 12 bolt GM, 9" Ford, 8-3/4" Mopar and '57-'64 Olds/Pontiac
Timken bearings for all Dana 60™ type rears.
Pinion nut washer for Dana 60™
For 35 spline Powr-Lok™ posi traction. Converts 23 spline carriers to 35 spline.
Rear Cover Gasket for Dana 60™
Original Equipment bolts set of 12.
3/8" diameter studs with nuts and washers. Set of 8.
Cast aluminum cover